|
DESCRIPTION: VOLVOX FLOOR SEALER is the new high
tech water based VOLVOX floor finishing product that meets the
strict EU VOC regulations even beyond the year 2010.
The hard wearing clear finish is suitable for all timber floors
made of hard & softwood. It is also suitable to seal
beautiful Australian hardwood flooring boards and parquetry. VOLVOX
Floor Sealer is self priming and will enhance the appearance of
wood colour and grain. The durable silky matt finish is resistant
to light and staining.
USE: VOLVOX Floor Sealer is ready to use.
Hardwoods as well as softwood flooring require three coats of
VOLVOX Floor Sealer with no priming. VOLVOX Floor Sealer can
also be used on other heavy traffic exposed timber surfaces, branch
tops, table tops, windows, furniture and children’s toys.
SURFACE PREPARATION: Provide a clean,
dry, firm and grease free surface. Timber floor boards and
parquetry should be sanded to at least 180 grit. Tropical
hardwoods should be degreased using a suitable thinner such as
VOLVOX Iso-Paraffin.
USE: Stir well and apply first coat in wood
grain direction. Use paint brush, roller or floor applicator.
Do not apply more then 65 to 75ml per square meter as too liberate
applied VOLVOX Floor Sealer will lengthen drying time.
Let first coat dry for 2 hours then cut back. (Sand) surface using
320 grit sand paper. Provide good ventilation during drying
and curing time. Remove dust and apply second & third coat
allowing drying of 2 hours between coats. Do not apply in
temperature below 15C or above 30C. Note that drying on cork and
Australian tannin reach wood could longer than 2 hours.
Test before sanding between first and second coat.
NOTE: Always stir well and poor through a
strainer to eliminate lumps. Do not use tools that you have
previously used with Solvent based paint (New Tools
recommended). If you are spraying the paint make sure your
tools are thoroughly cleaned as ant left over Thinners/Solvents
will create lumps.
COERAGE: Depending on surface condition
1L will cover 13 – 15m2 per coat. (0.75 L approx. 10m2 per
coat. 2.5L for approx. 33m2 per coat)
CLEAN UP: Clean tools with water after use
away from drains
STORAGE AND SHELF LIFE: Store tightly
sealed in a cool dry place. Minimum shelf lif for unopened and
properly stored cans is 12 months. Protect against freezing.
SAFETY: General Safety Requirements for the
application of floor finishing products are in force and must be
followed when using VOLVOX Floor Sealer. Provide adequate
ventilation during and after application. Do not smoke and avoid
skin contact. Please keep away from children.
DISPOSAL: Allow unwanted paint dry. Solid
matter should be disposed of via the normal garbage collection
service.
DISCLIMER: The user is recommended to test
the product on the surface to ensure its suitability.
THCHNICAL INFORMATION: Viscosity (at 20C)
70sec at 4mm DIN culp. EC71/3 suitable for coating children’s toys.
EU-DIN 53160 saliva and perspiration proof. EU-DIN 68861/1B
Exposure to chemicals. R20,21, 22. R36,38. R43. VOC <130/I (EU
VOC Regulation)
INGREDIENTS: Water, anti-skinning agent, silicic acid,
pure acrylate, butoxyethanole, methopyrrolidone, preservative.
View pdf
version |
